#windup #walker clothes

by Aki Nyrhinen 2 years ago
#windup #walker clothes CC BY-SA 3.0
Share with friends: Embed
Pin It
Link:
  • Tinkered by
  • Like
    7 Comments
    • Rev 151
    • Aki Nyrhinen 2 years ago
      requires a tiny bit of knifework when printed (to remove makerbot burr)
    • Kai Backman 2 years ago
      How does it snap on, would it require a small bevel to make it easier to attach?
    • Aki Nyrhinen 2 years ago
      it snaps on quite ok, detaching is very hard though.
    • Kai Backman 2 years ago
      That sounds about right based on a quick user testing session here at home. :-)
    • Rev 299
    • Aki Nyrhinen 2 years ago
      added a small bevel as kai suggested...
    • Rev 384
    • Aki Nyrhinen 2 years ago
      with the bevel, no burr removal is necessary. it prints out alright, though there is a period of exitement with the topmost parts of its head.
    • Rev 388
    • Agustin M Sevilla about a year ago
      Thank you so much for this one! It worked perfectly on my Printrbot! "Mr. Poto" #windup #walker?